Garland Gate Pros provides professional security fencing & perimeter in Garland, TX for residential and commercial properties across the Dallas metroplex. A gate is only as good as what stands beside it. Ornamental steel and aluminum fencing, welded panel, and heavier commercial-grade systems all get built and installed by the same shop that builds your gate, so the picket spacing, rail height and finish actually match instead of nearly matching.
Fence posts have a problem in Garland that gate posts do not. They are light, they are numerous, and nobody wants to drill deep piers for eighty of them. Clay swelling around a shallow, straight-sided collar lifts it slowly, and a run that was dead level at install develops a wandering top line. The fix is not exotic: correct depth, a footing shaped so soil cannot grip and jack it, and drainage at the base.
Slope handling is the other thing that separates a good fence from a cheap one. On a graded Garland lot, panels can either rack, following the ground as parallelograms, or step down in level increments. Racked runs look better on gentle grade; stepped runs look better on steep grade and keep pickets vertical. We will walk the line with you and mark which method goes where before anything is fabricated.
For commercial sites we build to a different spec entirely: heavier posts, closer spacing, welded rather than pressed connections, anti-climb picket profiles where they are justified, and coordination with whatever cameras, lighting or access control is going in at the same time. Fencing a truck yard and fencing a front garden are not the same product. Anti-climb detailing on a residential fence is usually money better spent on lighting.
Finish decides lifespan. Hot-dip galvanized steel under powder coat is the standard we use where sprinklers hit the fence line or where trees keep the base damp. Powder alone over bare steel looks identical on day one and does not last as long in those conditions, and we would rather tell you that at quoting time. Coating failure at ground level is the first thing we look for on any survey.
Gate posts and fence posts should not be the same detail, and where a run meets a driveway entry we make that explicit. The two posts either side of the opening are gate posts: bigger section, deeper pier, sized for the leaf. The fence begins at the next post along. Contractors who carry the fence spec straight through the opening are the reason so many entries lean within three seasons.
Repairs are a real part of this work. Vehicle damage, storm damage, leaning posts and sections that were never set deep enough by whoever came before us. We can usually replace a run rather than a fence, and match the finish closely enough that the repair stops being visible. Matching an older fence is easier than people assume when the original profiles are still made, and we will tell you up front when they are not.
With 15+ years of experience, our insured team brings the right materials and equipment to every job — wrought iron and ornamental steel fabrication, powder-coated aluminum gates, truck-rated cantilever slide gates, LiftMaster, DoorKing and FAAC operators, Class I-IV operator classifications, UL 325 entrapment protection — and backs the work with a written workmanship warranty. We serve Garland and nearby communities including Richardson, Mesquite, Rowlett, Plano.
What We Handle
Everything our security fencing & perimeter in Garland covers
One crew, one point of contact, and the full range of security fencing & perimeter work in Garland, TX. If it is on this list we do it in house rather than handing it to a subcontractor:
- security fencing installation
- wrought iron fencing
- ornamental steel fence panels
- aluminum fencing
- perimeter security fencing
- matching fence and gate packages
- anti-climb fencing
- pipe and cable ranch fencing
- commercial perimeter fencing
- terminal and corner post setting
- fence panel replacement
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Garland services.
Materials, equipment and how we do security fencing & perimeter
The difference between security fencing & perimeter that lasts and security fencing & perimeter that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with wrought iron and ornamental steel fabrication, powder-coated aluminum gates, truck-rated cantilever slide gates, LiftMaster, DoorKing and FAAC operators, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Garland job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of gate work in the Dallas metroplex means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do security fencing & perimeter outside Garland
Garland Gate Pros covers Garland and the surrounding communities of the Dallas metroplex. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Security Fencing & Perimeter in Richardson, TX — Dallas County, population 120,000
- Security Fencing & Perimeter in Mesquite, TX — Dallas County, population 150,000
- Security Fencing & Perimeter in Rowlett, TX — Dallas County, population 65,000
- Security Fencing & Perimeter in Plano, TX — Collin County, population 285,000
- Security Fencing & Perimeter in Sachse, TX — Dallas and Collin Counties, population 28,000
- Security Fencing & Perimeter in Wylie, TX — Collin County, population 60,000
Start on the Garland Gate Pros homepage for a free estimate, or call (877) 757-4456 and describe the job.
Why Garland Chooses Garland Gate Pros
- ✓Over 15 years installing and automating gates across the Dallas metroplex
- ✓In-house welding shop — we fabricate and coat our own gates rather than reselling panels
- ✓Deep footings engineered for North Texas blackland clay, so gates stay square
- ✓Every operator wired to UL 325 with photo eyes, loop detectors and tested entrapment protection
The standards behind security fencing & perimeter
Quality here is not a matter of opinion — it is written down. The security fencing & perimeter work we do in Garland follows published industry standards: DASMA is the standards body for door and access systems, and UL Solutions publishes UL 325, the safety standard for automatic gate operators. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every security fencing & perimeter project in Garland gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (877) 757-4456 for a free security fencing & perimeter free estimate in Garland, or request a quote and we'll get right back to you.